FMS 1000

Telematics IoT Gateway
  • Main Feature
  • 1 x 10/100 Mbps Ethernet
  • 3G WWAN and WLAN support
  • Rugged IP67 protection
  • Back up rechargeable battery
  • SMS message triggered by event
  • 2 x CAN Bus 2.0B
  • Driver identification support (iButton & RFID)
  • Support optional USB storage as data logger
Add to Inquiry
Datasheet(PDF)
WWAN Connection UMTS/HSPA: 800, 850, 900, 1700, 1900, 2100MHz GSM/GPRS/EDGE: Quad band 850, 900, 1800, 1900
WLAN Connection (Option) 802.11 b/g/n, 2.4GHz
Ethernet 1 x 10/100 Mbps Ethernet
On Board Sensors 1 x G-sensor
Serial Port 1 x RS232 for optional RFID reader (w/12VDC output)
Voice Communication (option) 1 x MIC-in 1 x Line-out
GPS On board u-blox, NEO-M8N GPS module Support GPS/Gloness/QZSS/Galileo/Beidou Support optional precision GPS module Support optional GPS Dead Reckoning
SMS Message Triggered by events
Battery Li Polymer rechargeable back up battery, 1200mAh
Digital Input/Output 3 x DI 3 x DO
Analog Input 3 x Analog-In
Input: 0~38V
Resolution: 12 bit
CAN Bus 2.0B 2 x CAN Bus 2.0B
Storage 1MB on board memory Optional USB-Disk Module (up to 64GB)
Other Interfaces iButton for driver identification Frequency input for vehicle speed detection 1 x direction signal for optional GPS DR module
Configuration Setting Via Ethernet
I/O Interface - Front Power/ignition/GND input 2 x CAN Bus 2.0B 3 x DI and 3 x DO 3 x Analog-In 1 x Speed frequency-Input 1 x Direction signal 1 x 1Wire iButton 1 x Mic-In 1 x Line-Out 1 x Ethernet 1 x 12VDC output 1 x RS 232 3 x antenna for GPS/WWAN/Wi-Fi
LED Indicators - Top Cover 1 x Power LED 1 x GPS LED 1 x Wi-Fi LED 1 x WWAN LED
Power Management 9 ~ 36VDC input 8-level power off delay time
Dimensions 153 mm (W) x 146 mm (D) x 56 mm (H) (6" x 5.75" x 2.2")
Environment Operating temperatures:
-40°C~70°C (w/o battery)
-20°C~60°C (w/ battery, discharging)
Storage temperatures:
-40°C ~ 80°C
Relative humidity:
10% to 90% (non-condensing)
Vibration:
2g@5 ~ 500Hz
Operating: MIL-STD-810G, Method 514.6, Category 4, common carrier US highway truck vibration exposure
Storage: MIL-STD-810G, Method 514.6, Category 24, minimum integrity test
Shock:
Operating: MIL-STD-810G, Method 516.6, Procedure I, functional shock=20g
Non-operating: MIL-STD-810G, Method 516.6, Procedure V, crash hazard shock test=75g
Certifications CE approval FCC Class B E13 Mark
Add to Inquiry
Take a minute and tell us what you think!